Gender
Male
About
Location
Gtr Manchester
About Me:
I'm a heli flyer but getting into Quad/Hex in a big way. Been flying 3 years and work in the computer industry
Please tell us a bit about your UAV interest
I'm working with NHP to produce an all carbon Quad/Hex/Oct frame to be supplied with a fully configured Ardu
Hometown:
Altrincham
Activity Feed
The I value is a bit suspicious, it flys perfectly (if a little to aggressive)Is this an expected result from Auto Tune ?NewPids.png
"Logs Att.
Thanks2016-05-15 10-36-45.bin"
Thanks2016-05-15 10-36-45.bin"
I've calibrated the compass (using methods in various YT videos) several times. Each time I get different offsets for the calibration even though the machine hardware and location remains the same.On every flight I get EKF warning of compass…
"Have the same setup - Can't get the T4-3d to see sbus channels greater than CH9
Does the pix just replicate the input sbus signal or is it more intelligent
Just looking for Docs now ...."
Does the pix just replicate the input sbus signal or is it more intelligent
Just looking for Docs now ...."
I'm not certain this is the correct place for this question but here goes..After a crash and identified ESC fault All ESC have been replaced on the Octo.The replacement ESC are Opto so the pixhawk is being powered purely by the pixhawk power…
"You can see RC out on the Tlog - I've ordered replacement ESC's - looks very much like ESC 8 went bad."
First field trip since update.After doing calibrations in the field first flight was going well until about a minute in. I was in loiter hovering level, just tilting the camera down when the back of the Octocopter dipped violently, lost lots of…
"Logs show a power failure to all motors - RCoutput is increased but no response in altitude - My interpretation would be main power failure."
"Looking further I can see the log file is corrupt - please post the original BIN file."
"However - there are values in the RAW data for RCOU(6) - might be a MP graph fault."
"RCOU data for output channel 6 shows zero output to channel 6 through the whole flight"
"It seems obvious from the log that there was a mechanical failure on one of the motors."
"Ok, the title is a little mis-leading, its not a flyaway. But that might be flyaway prevention that landed it.
I'll stick my neck out and suggest you have EKF turned on and that was an EKF failsafe."
I'll stick my neck out and suggest you have EKF turned on and that was an EKF failsafe."
"Its not there for pixhawk any more, just click calibrate and follow the instructions."
No problems in flight to mention but got a strange problem on the gimbal (nothing to do with the Pixhawk).whilst looking at the logs I noticed more vibration than normal (at least from what I can remember) The soundtrack on the camera also makes me…
"Wow - only the first part of my post appeared....
It should say - I think you need to tidy the cables first, they will tug on the pixhawk and cause vibrations"
It should say - I think you need to tidy the cables first, they will tug on the pixhawk and cause vibrations"
