About

About Me:

Working on UAV project


Please tell us a bit about your UAV interest

Working on UAV project


Hometown:

Los Angeles


Activity Feed

Tim Mulder replied to Tim Mulder's discussion Auto-Takeoff Fixed Wing
"Just seeing if anyone had any thoughts?"
Mar 3, 2015
Tim Mulder replied to Tim Mulder's discussion Auto-Takeoff Fixed Wing
"Anyone?"
Feb 27, 2015
Tim Mulder replied to Tim Mulder's discussion Auto-Takeoff Fixed Wing
"If anyone has experience with this and can tell me what to expect I would much appreciate it. Thanks."
Feb 23, 2015
Tim Mulder posted a discussion
I have a fixed wing tricycle gear airplane I am trying to implement auto-takeoff with. Also, I am not using an airspeed sensor so I would need to hold a constant climb pitch. Testing the feature with the engine off I see that the throttle goes to…
Feb 23, 2015
Tim Mulder replied to Tim Mulder's discussion Pixhawk vs APM 2.6 Reliability?
"We had one crash, which I believe was due to a receiver failure in manual mode and fail safes where not setup correctly, however, I saw a similar experience with another DIY Drones member and they believe it was something to do with the Pixhawk.  …"
Sep 27, 2014
Tim Mulder posted a discussion
I have used both the APM 2.6 and Pixhawk (fixed-wing aircraft), however, I seem to have had greater success with the APM.  I would like to hear from those that have also had experience with both (used on fixed-wing aircraft) and see which one you…
Sep 27, 2014
Tim Mulder posted a discussion
I have found the setting within the parameters that enables the use of a second GPS.  I am assuming that the firmware automatically selects whichever GPS has the lower HDOP.I am under the impression that the Pixhawk has dual baros and…
Sep 26, 2014
Tim Mulder posted a discussion
When using the power module with the APM, what is the minimum recommended C rating of a Lipo battery?
Mar 30, 2014
Tim Mulder replied to Tim Mulder's discussion Y-Harness Dual Rudder Problem Issue
"Tried that, but same situation."
Mar 24, 2014
Tim Mulder replied to Tim Mulder's discussion Y-Harness Dual Rudder Problem Issue
"If each servo is independently connected to the APM then they work fine.  It is only when using the Y-harness and it is just one rudder.  I have tried another y-harness with no luck, as well I have tried another receiver."
Mar 23, 2014
Tim Mulder posted discussions
Mar 23, 2014
Tim Mulder replied to Tim Mulder's discussion 2 Servo Elevator Setup
"yes, they need to be mixed for optimum performance."
Mar 20, 2014
Tim Mulder posted a discussion
I have a 2 servo elevator setup which is mixed with my controller (One servo plugged into elevator channel, one plugged into aux).  How can I get this to work with Ardupilot?  Thanks.
Mar 20, 2014
Tim Mulder posted a discussion
Could this be used for 3g telemetry (http://www.netcommwireless.com/product/m2m/ntc-4000)?
Nov 19, 2013
Tim Mulder left a comment on Telemetry over cellular IP
"Anyone have any thoughts on using this (http://www.netcommwireless.com/product/m2m/ntc-4000) for 3g telemetry?"
Nov 15, 2013
Tim Mulder posted a discussion in Telemetry over cellular IP
Could this be used for 3g telemetry (http://www.netcommwireless.com/product/m2m/ntc-4000)?  
Nov 15, 2013
More…