Gender
Male
About
Location
Lviv
Please tell us a bit about your UAV interest
Motocross, cycling, programming and UAVs
Hometown:
Lviv
Activity Feed
"There are also BattGo batteries."
"Yes, but they wrote about generic "BAD ACCEL HEALTH" one. It can be IMU1 fail."
"Hi.
So does LSM303D issue affects only Pixhawk clones or 3DR boards too?
My own experience shows that original ones aren't affected.
I'm sorry in case you pointed it somewhere earlier."
So does LSM303D issue affects only Pixhawk clones or 3DR boards too?
My own experience shows that original ones aren't affected.
I'm sorry in case you pointed it somewhere earlier."
"Is your first power module from HK too?
I had similar problem with incorrent measurents too. My PM showed more than 1V difference. The problem was caused by bad wires(!!!) from PM to PX. I measured wire resistance and it was around 1 Ohm."
I had similar problem with incorrent measurents too. My PM showed more than 1V difference. The problem was caused by bad wires(!!!) from PM to PX. I measured wire resistance and it was around 1 Ohm."
"Hmm. I thought it is possible to use only one radio on repeater aircraft with SiK multipoint. Such setup can be done without multipoint support in firmware, i guess."
"It weights 14g+-2g."
"Hi, Nick. I tried to use the board with APM firmware (APM:Plane 3.3, also tried older versions), but i receive "Calibration FAILED" message every time i try to calibrate an accelerometer.
It works well in PX4."
It works well in PX4."
"AFAIK the autopilot mainly relies on external compass. Most people (and me) fly with such setup but it doesn't cause crashes. The autopilot considers compass errors level (and maybe compass location (internal or external)) to avoid usage of wrong…"
"@turdsurfer, thanks for the info. I've almost bought the AP, but i need LRS support. Is there some way to avoid the noise? Can i be shielded?"
"Yes, you can connect MinimOSD on the ground.
I think you'll need to use single radio."
I think you'll need to use single radio."
"Yes, it should work.
I've done it with Digi Xtend. It is a similar digital modem."
I've done it with Digi Xtend. It is a similar digital modem."
"Hi. Everyone who want to build own RPi-based copter can use this open-source code: https://bitbucket.org/lastsurvivor/innode/overview :)"
"Thank you, i`ll try.
Do you know any OpenSource software for RasPi-based copters?
Does everyone else heve any progress?"
Do you know any OpenSource software for RasPi-based copters?
Does everyone else heve any progress?"
"Hi. I finished to build my copter yesterday. And i broked all propellers :)
I have the flight base now and can start integrate RasPI into my copter.
I will use WiFi for the communication and webcam for FPV.
Also i will use existing MultiWii for…"
I have the flight base now and can start integrate RasPI into my copter.
I will use WiFi for the communication and webcam for FPV.
Also i will use existing MultiWii for…"
