AeroQuad (154)

Discussions Replies Latest Activity

Launch of Xbotics a new E-commerce website

Avian Aerospace takes pride to launch Xbotics- an e-commerce platform with extended support from the team to guide/ train you while you exp…

Started by Xbotis

0 Jul 28

Hybrid power system

Hello, I am currently working on making a hybrid power system using IC engine and generator/ alternator/ motor for a UAV (VTOL capability -…

Started by Lekhraj Rana

7 Jun 21
Reply by Giuseppe

3D Acrobatics

Hi All I have a Helimax Voltage 500 3D quad and I am considering upgrading the electronics. Does anyone have any good recommendations for c…

Started by Phil Toler

0 Jun 13

accident investigation

Hi,  can any body help me to detect the reason of accident from this log ? I have gone through entire flight log and found out the anomaly…

Started by ashwani gupta

0 Apr 3

Tethered drone power

Hello - Regarding a powered tether supplying 220AC up to the drone. I see some using an expensive ($1000) TDK AC-DC converter on board the…

Started by Bob Jestico

0 Feb 21

Motors Not Properly Working

I currently am using a Naza M Lite and Emax motors on my S500. However, when I raise the throttle to max and then lower the throttle one of…

Started by Connor

0 Sep 7, 2017

Help! flight times only 2 and a half minutes

Just got a open box f210 3D have to batterys using a balance charger at 1 amp one battery is walkera the other brand new turnigy 1300mh bot…

Started by Diven Parker

2 Jun 26, 2017
Reply by christopher.shiny

What do you think of the Sunnsky E2306-2700KV?

Last week we got the test results of E2306-2700KV from MQTB as below: The results was tested by Ryan Harrell wit…

Started by Sam Tan

0 Apr 5, 2017

Safety Survey V2.0

SURVEY Questions are: Do you currently own a DJI Phantom of any version? Would you use a Multi-Rotor Safety Shield (MRSS) if it did not af…

Started by bob cooper

0 Apr 5, 2017

Powering Pixhawk

Hello, My pixhawk is being very temperamental.  I am powering it from a 5.4V supply from my PDB and connecting that through the servo rail…

Started by Robert Brown

0 Mar 7, 2017

RSS

© 2018   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service