ESCs/BECs/Servos (262)

Discussions Replies Latest Activity

ESC constant beeping with pixhawk 2.4.8

Hello everyone! It's my first discussion on DIY DRONES. I had to do this because of a very annoying ESC beeping problem. I have 30amp ESC…

Started by Priyansh Raj Purohit

2 Oct 29
Reply by Priyansh Raj Purohit

Is full throttle better for the ESC then 75% or 50% throttle ?

I have read that an ESC is not using the same cooling internal circuit while operating at 100% or at 50 / 75%, and that therefore, the ESC…

Started by

3 Jul 30
Reply by Hans H.

Need help with a motor

Hello I have a problem with my drone (which I am building). Practically when I arm the engines the number of laps, set by me on cleanflight…

Started by Domenico

1 Jul 15
Reply by Prasanna Shevare

ESC Question

Hi, I just need clarification. Say I have a T motor U10-100KV and according to the thrust table at max thrust with 30'' props I consume 32A…

Started by Josh

0 Jul 4

DYS BLHeli 40A Opto on Plane

Hello I will use in a plane a DYS BLHeli 40A Opto. I've never used this type of ESC and I've seen a lot of discussion about it. Should I ta…


0 Apr 19

Controlling ESC output through a Raspberry Pi Zero W

I am working on a project to build a quadrotor using RPi Zero W as flight controller. It has 2 main parts. 1) Recieving RC signal (FS-R6B A…

Started by Muhammad Waqas Kayani

0 Apr 17

PDB setup for a twin rotor plane using a quad rotor PDB

Hello all, I'm very new to drone building, and have set myself a challenge of creating a twin motor fixed wing plane. I will be using two b…

Started by Vito Cientanni

0 Mar 31

ESCs don't like cold weather - known problem?

Hi there, today I went out to test the new 2.1 Arducopter firmware and was surprised, when all 4 ESCs made the motors beep on start-up,  (l…

Started by jjohow

14 Mar 28
Reply by Den Cath

motor driver suggestion.

Hey forum, I'm trying to build a rover that uses dc motors with apm (2.8) and an L298p motor shield (that was for Arduino).But I found out…

Started by Jun kyung Bang

0 Feb 27

Split 5v BEC line to power several peripherals

Hi all. I am putting together a fixed wing UAV with a Pixhawk 2.1 flight controller, four 9-gram servos, dragonlink rx, RFD900 telemetry, a…

Started by Boas61

0 Feb 7



Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2018   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service