MHA's Discussions (108)

Discussions Replied To (98) Replies Latest Activity

"This is my current PID's "

MHA replied Apr 24, 2014 to APM 3.1-rc4 yaw PID tuning

57 May 25, 2015
Reply by Massimo Tabai

"Had exactly the same with one of the 3.1.2rc's. Luckily this was only hovering 1-2 f…"

MHA replied Feb 25, 2014 to unexpected engines shutdown APM 2.6 + Arducopter 3.1.2

3 Apr 16, 2014
Reply by json

Developer

"Guys, Randy,   Just a simple question: is there a difference between a radio f/s ini…"

MHA replied Dec 10, 2013 to ArduCopter-3.0.1 released!

5021 Feb 18, 2016
Reply by Andrew A

Developer

"Hi Randy, does this version use the same gcc version as the linux build suite? I.e.…"

MHA replied Nov 23, 2013 to ArduCopter-3.0.1 released!

5021 Feb 18, 2016
Reply by Andrew A

Developer

"Hi Randy, Unfortunately it is not possible to set individual f/s values in ppm mode…"

MHA replied Nov 23, 2013 to ArduCopter-3.0.1 released!

5021 Feb 18, 2016
Reply by Andrew A

Developer

"I also proposed this. Think it would be a very good compromise and should make eithe…"

MHA replied Nov 17, 2013 to ArduCopter-3.0.1 released!

5021 Feb 18, 2016
Reply by Andrew A

Developer

"Leonard, guys, I am confused about the ACRO default settings. In an earlier post it…"

MHA replied Nov 17, 2013 to ArduCopter-3.0.1 released!

5021 Feb 18, 2016
Reply by Andrew A

Developer

"Hi Randy,    I had a look at the ArduPPM code. Shorting pin 2&3 puts the encoder…"

MHA replied Nov 15, 2013 to ArduCopter-3.0.1 released!

5021 Feb 18, 2016
Reply by Andrew A

Developer

"Hi Randy, My bench test was done with MP not connected. I know RX/TX behave differen…"

MHA replied Nov 15, 2013 to ArduCopter-3.0.1 released!

5021 Feb 18, 2016
Reply by Andrew A

Developer

"Hi Randy, I did a bench test again and recorded a tlog. Yes, it takes 2 seconds. Thi…"

MHA replied Nov 14, 2013 to ArduCopter-3.0.1 released!

5021 Feb 18, 2016
Reply by Andrew A

RSS

Groups

Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service