Chris's Discussions (20)

Discussions Replied To (18) Replies Latest Activity

"i have used a Delta Mix Modul at one Input from this Module comes Aileron Signal fro…"

Chris replied Mar 19, 2012 to ailerons on 2 chanels

4 Mar 20, 2012
Reply by PeterTN

"i am here like a alone converser but no problem you should hear about the bad boards…"

Chris replied May 18, 2011 to Ardupilot is scrap

5 May 18, 2011
Reply by Chris Anderson

"so past the first anger about the shit part i am back from the airfield and have che…"

Chris replied May 17, 2011 to Ardupilot is scrap

5 May 18, 2011
Reply by Chris Anderson

"hello there first i have self the EM-406 and works only for RTL then i changed to or…"

Chris replied May 17, 2011 to GPS module EM-411/406A and ArduIMU/Ardushield V2

1 May 17, 2011
Reply by Chris

"use the dip switch to reverse the direction and read the manuals for setup the board…"

Chris replied May 1, 2011 to Stabilize problem

2 May 1, 2011
Reply by Hector R. Santini

"i think that is not right again because if you have this problems you will try as fi…"

Chris replied Apr 27, 2011 to Delay in Servo Actuation using Ardupilot Mega

19 Apr 28, 2011
Reply by Matthias Badaire

"ok but then it should have no a delay at manual mode  this could be dangerous for th…"

Chris replied Apr 23, 2011 to Delay in Servo Actuation using Ardupilot Mega

19 Apr 28, 2011
Reply by Matthias Badaire

"no the PPM encoder is not the reason for that if the servos are run by delay then is…"

Chris replied Apr 22, 2011 to Delay in Servo Actuation using Ardupilot Mega

19 Apr 28, 2011
Reply by Matthias Badaire

"i had the same Problem if i try to use the Firmware from upload via AMP it looks lik…"

Chris replied Apr 22, 2011 to Delay in Servo Actuation using Ardupilot Mega

19 Apr 28, 2011
Reply by Matthias Badaire

"Hello Chris, past my last test with the original firmware via APM (and strange servo…"

Chris replied Apr 22, 2011 to Waypoints not working

18 May 6, 2011
Reply by Lenildo Santos da Silva

RSS

© 2020   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service