Stephan's Discussions (42)

Discussions Replied To (39) Replies Latest Activity

"Good summary Felipe. A couple more to add: - ensure that Wifi is always turned off o…"

Stephan replied Jun 19, 2015 to Fool proof guide for newbies to avoid flyaways or disarm problems?

43 Jun 24, 2015
Reply by Paul

Developer

"I even go for 3.3V/cell under load. You are perfectly safe as long as voltage/cell d…"

Stephan replied Jun 19, 2015 to Copter-3.3 beta testing

5648 Jun 20, 2016
Reply by Cala

Developer

"@Randy, will the Solo use the same 3.3 code base or did you do a code split?"

Stephan replied Jun 1, 2015 to Copter-3.3 beta testing

5648 Jun 20, 2016
Reply by Cala

Developer

"Igor, how many Amps is your setup pulling? The Multistar are extremely weak under hi…"

Stephan replied May 30, 2015 to Copter-3.3 beta testing

5648 Jun 20, 2016
Reply by Cala

"Thanks, works fine. :)"

Stephan replied Dec 27, 2014 to How to obtain higher speed in follow me and loiter mode?

3 Jan 24
Reply by Ritesh Pal

"In MP CLI is still available with 3.2. If you get a constant stream of "garbage" dis…"

Stephan replied Dec 6, 2014 to CLI Giving Garbage with APM 2.6 with 3.2 firmware

21 Aug 25, 2015
Reply by Jake Ruebel

"1. No. 2. 900MHz is illegal in Europe, and yes, they can locate you if anyone report…"

Stephan replied Dec 3, 2014 to 900Mhz is illegal here but I need just to test

5 Dec 4, 2014
Reply by Johnatan

"Ok, the motor sound indicates a wrong timing of the ESCs. This would explain why its…"

Stephan replied Dec 3, 2014 to Copter tried to kill me, Grinding noise then stuck at full throttle.

18 Dec 7, 2014
Reply by Chris Anderson

"I ran into the same issue with APM 3.2. After reading through all available forums I…"

Stephan replied Dec 2, 2014 to Why are motors not getting full power from arducopter

55 Mar 20, 2017
Reply by Juan Arnes

RSS

Groups

Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service