max246's Discussions (24)

Discussions Replied To (17) Replies Latest Activity

"to make the A11 working, you need to setup the gimbal settings as output the A11 and…"

max246 replied Nov 7, 2013 to How to output servo signal from APM output?

4 May 11, 2014
Reply by turdsurfer

"Anyone?!"

max246 replied Nov 7, 2013 to Override target Altitude holder

1 Nov 7, 2013
Reply by max246

"You need to enable on the gimbal and setup the output on the A-port of the APM and t…"

max246 replied Nov 7, 2013 to How to output servo signal from APM output?

4 May 11, 2014
Reply by turdsurfer

"Any idea? nobody?"

max246 replied Aug 28, 2013 to Altitude holder problems

10 Sep 11, 2013
Reply by Aerhead

"I have checked back all screws and motors, it seems to be everthing fine and I did a…"

max246 replied Aug 8, 2013 to Problem with Arducopter 3.0.1 and APM 1

2 Sep 21, 2013
Reply by Dave Jeffries

"Did you do the calibration of your remote controller? You should do it each time tha…"

max246 replied Nov 26, 2012 to Modifying Code for Hexacopter

10 Nov 27, 2012
Reply by Georg

"Nobody?!"

max246 replied Nov 26, 2012 to Arducopter 2.8.1 on my APM 1

3 Dec 4, 2012
Reply by Robert Spiteri

"I didn't understand how the configuration works, does the config.h is helpful if you…"

max246 replied Nov 26, 2012 to Modifying Code for Hexacopter

10 Nov 27, 2012
Reply by Georg

"I am not 100% sure, but I was changing some code on my Hex copter and I have updated…"

max246 replied Nov 26, 2012 to Modifying Code for Hexacopter

10 Nov 27, 2012
Reply by Georg

"There is the file APM_Config.h, enable the configuration of your drone"

max246 replied Nov 26, 2012 to Modifying Code for Hexacopter

10 Nov 27, 2012
Reply by Georg

RSS

Groups

Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service