Don Pillow's Discussions (35)

Discussions Replied To (29) Replies Latest Activity

"Getting a little busy around home. I am hoping to keep up with some writing on the p…"

Don Pillow replied Apr 9, 2016 to Design a hexacopter with coaxial rotors

4 Jun 10, 2016
Reply by Keith Bouckley

"I have the controller (ArduCopter), gps and landing gear installed. Tested all the m…"

Don Pillow replied Feb 27, 2016 to Another 0cto design

5 Feb 27, 2016
Reply by Don Pillow

"Just bought a HK fabrikator when they were on black friday sale. Works pretty good a…"

Don Pillow replied Feb 27, 2016 to Another 0cto design

5 Feb 27, 2016
Reply by Don Pillow

"The motor mounts will be 2.5mm thick here and are 3mm on my big ones which I have ha…"

Don Pillow replied Feb 21, 2016 to Another 0cto design

5 Feb 27, 2016
Reply by Don Pillow

"Mike, you are correct--I don't know if there was a good lock. I do know that I alway…"

Don Pillow replied Dec 14, 2015 to arducopter flight problems

6 Dec 14, 2015
Reply by Mike Kelly

"Had good gps signal. It did not go into rtl by itself. I did it when loiter started…"

Don Pillow replied Dec 12, 2015 to arducopter flight problems

6 Dec 14, 2015
Reply by Mike Kelly

"Found the problem. I have been using the cable that came with the cuav and just noti…"

Don Pillow replied Nov 28, 2015 to New heavy lift design

32 Dec 1, 2015
Reply by Tommy Larsen

"ready to fly this thing but can't get the 3dr telemetry to connect to tne Mission pl…"

Don Pillow replied Nov 28, 2015 to New heavy lift design

32 Dec 1, 2015
Reply by Tommy Larsen

"The motor mounts on this one are designed with grommets in each mounting hole sandwi…"

Don Pillow replied Nov 22, 2015 to New heavy lift design

32 Dec 1, 2015
Reply by Tommy Larsen

"There are lots of discussions no the subject and multi's with the motors slung under…"

Don Pillow replied Nov 22, 2015 to New heavy lift design

32 Dec 1, 2015
Reply by Tommy Larsen

RSS

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service