leopoldo ojea's Discussions (48)

Discussions Replied To (37) Replies Latest Activity

"Thank you so much... I was in simple.... Best regards, Leopoldo "

leopoldo ojea replied May 29, 2016 to IOC in a Pixhawk??

3 May 29, 2016
Reply by James

"Hi Brian, I have forgotten to thank you, I did it and it works great!!!!! Thank a lo…"

leopoldo ojea replied May 25, 2016 to Plane-waypoint set up

2 May 25, 2016
Reply by leopoldo ojea

Developer

"Hello, I have three AP;  one 2.0, another one 2.5 both are from 3DR  for my aeroplan…"

leopoldo ojea replied Apr 4, 2014 to ArduCopter-3.0 ready for wider use

1570 May 7, 2014
Reply by Hangingpixels

Developer

"Hello,   I have three AP;  one 2.0, another one 2.5 both are from 3DR and one 2.5 fr…"

leopoldo ojea replied Apr 3, 2014 to ArduCopter-3.0.1 released!

5021 Feb 18, 2016
Reply by Andrew A

"Pieter I have 0,08 volts in L2C port, conector.  I messure in both side of the port…"

leopoldo ojea replied Jan 14, 2014 to APM 2.5 initial set up problem process

4 Jan 14, 2014
Reply by Pieter

"Thank Pieter, I will check today and let you know. Best Regards, Leopoldo"

leopoldo ojea replied Jan 14, 2014 to APM 2.5 initial set up problem process

4 Jan 14, 2014
Reply by Pieter

"Oh excuse me it is a APM 2.5 board"

leopoldo ojea replied Jan 4, 2014 to APM 2.5 no USB after ESC calibration

8 Jan 4, 2014
Reply by leopoldo ojea

"Hi Jani, I have almost the same problem yannick, also I am new with APM, and run the…"

leopoldo ojea replied Jan 4, 2014 to APM 2.5 no USB after ESC calibration

8 Jan 4, 2014
Reply by leopoldo ojea

100KM

"Marco, I have the same GPs and I would like to connect it in the APM 2.5. Could you…"

leopoldo ojea replied Jul 18, 2013 to APM 2.5 with NEO-6M ublox gps (not 3DR LEA-6)

303 Feb 6, 2016
Reply by Nikos

100KM

"Marco, I have the same GPs and I would like to connect it in the APM 2.5. Could you…"

leopoldo ojea replied Jul 18, 2013 to APM 2.5 with NEO-6M ublox gps (not 3DR LEA-6)

303 Feb 6, 2016
Reply by Nikos

RSS

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service