Nolan Crook's Discussions (24)

Discussions Replied To (18) Replies Latest Activity

"what do you mean that the pixhawk restarted?  Did you hear the startup noises again?…"

Nolan Crook replied Feb 26, 2015 to Esc calibration and motor spinning problem

2 Mar 1, 2015
Reply by EchoSakura

"Hi Joe, I've been able to interface my ardupilot with several computers, I've never…"

Nolan Crook replied Aug 30, 2014 to APM 2.5.2 Won't Install Firmware/Connect Mavlink - TX and RX constantly blinking

32 Jan 20, 2017
Reply by Queiroz Jones

"It turns out that the voltage regulator off the battery I was using was dead and giv…"

Nolan Crook replied Jul 2, 2014 to APM 2.5.2 Won't Install Firmware/Connect Mavlink - TX and RX constantly blinking

32 Jan 20, 2017
Reply by Queiroz Jones

"Hi Javier, I had the same thing happen to me with my pixhawk.  I had to push the sa…"

Nolan Crook replied Jun 10, 2014 to Pixhawk wont spin motors after arming...

24 Oct 2, 2016
Reply by Wally

"I know this is late...but just for reference for people with the same problem.  I ha…"

Nolan Crook replied Apr 18, 2014 to Pixhawk wont spin motors after arming...

24 Oct 2, 2016
Reply by Wally

"The PM that I was using that fried it was a 3DR PM that was about a year old.  When…"

Nolan Crook replied Mar 22, 2014 to APM 2.6 FRIED from broken Power Module - Salvage??

3 Mar 22, 2014
Reply by Nolan Crook

"For clarification, have not been using JP1, only was powering through battery (XT-60…"

Nolan Crook replied Mar 21, 2014 to APM 2.6 FRIED from broken Power Module - Salvage??

3 Mar 22, 2014
Reply by Nolan Crook

"Are there any places on the board that I can check voltage to rule out hardware fail…"

Nolan Crook replied Mar 21, 2014 to APM 2.6 - No USB communication - Tried to flash but no success

3 Mar 21, 2014
Reply by Nolan Crook

"I searched through your posts to find the info on the sonar setup but was unable to…"

Nolan Crook replied Mar 20, 2014 to Obstacle avoidance with Sonar

5 Jul 13, 2016
Reply by Will Fellmeth

"Yeah I wish I had some.  Was looking at buying some last night but they aren't cheap…"

Nolan Crook replied Mar 20, 2014 to APM 2.6 - No USB communication - Tried to flash but no success

3 Mar 21, 2014
Reply by Nolan Crook

RSS

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service