Andrew Adams's Discussions (108)

Discussions Replied To (94) Replies Latest Activity

Wiki Ninja

"Well I fell dumb...I hadn't updated the firmware in so long that it was a version pr…"

Andrew Adams replied Oct 1, 2013 to 3DR radios will not connect for initial setup *** SOLVED ***

17 Aug 30, 2017
Reply by Shyam Balasubramanian

Wiki Ninja

"As far as I can tell, everything is set for 57.6k. I can read and set the settings…"

Andrew Adams replied Oct 1, 2013 to 3DR radios will not connect for initial setup *** SOLVED ***

17 Aug 30, 2017
Reply by Shyam Balasubramanian

Wiki Ninja

"Hate to bring up an old thread, but I'm having a similar issue. I have an APM 1 and…"

Andrew Adams replied Oct 1, 2013 to 3DR radios will not connect for initial setup *** SOLVED ***

17 Aug 30, 2017
Reply by Shyam Balasubramanian

"I got most everything from here. They aren't cheap, but it's a high quality product…"

Andrew Adams replied Jun 21, 2012 to Another Hexacopter Build

2 Jun 21, 2012
Reply by Andrew Adams

"check this thread out....http://www.diydrones.com/forum/topics/spektrum-dx8-and-ar80…"

Andrew Adams replied May 11, 2012 to Can't calibrate radio with APM2

21 Aug 18, 2012
Reply by Drone Savant

"EDIT: I just read, and learned, that on that Rx the signal is on the bottom. Maybe…"

Andrew Adams replied May 11, 2012 to Can't calibrate radio with APM2

21 Aug 18, 2012
Reply by Drone Savant

"Finally got around to messing with my copter and solved all my problems. I reloaded…"

Andrew Adams replied May 10, 2012 to Unable to arm hexa

18 May 10, 2012
Reply by Andrew Adams

"I would calibrate them again just in case..It's not too hard when doing it automatic…"

Andrew Adams replied May 10, 2012 to APM 2 ESC beeping rapidly

11 Sep 24, 2016
Reply by Phil Mathieson

"Make sure they are calibrated...I am having the same issue, however, I have an APM1.…"

Andrew Adams replied May 10, 2012 to APM 2 ESC beeping rapidly

11 Sep 24, 2016
Reply by Phil Mathieson

"What do they motors do when you the arming LED goes solid? Are they beeping? Pictur…"

Andrew Adams replied May 9, 2012 to cannot start motors on HEX w/APM1

6 May 10, 2012
Reply by Grahame Harvey

RSS

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service