Craig's Discussions (363)

Discussions Replied To (344) Replies Latest Activity

"open MP then press Control F then click on Param Gen on the left. Close everything a…"

Craig replied Feb 17, 2017 to Mission Planner latest version

2 Feb 17, 2017
Reply by Bernardo

"have you tried setting your limits on the radio itself?"

Craig replied Feb 16, 2017 to Cannot download APMCopter V3.4.5 via Mission Planner

4 Feb 16, 2017
Reply by Jerald Thompson

"did you make sure to reset all your settings and then run a full calibration?"

Craig replied Feb 16, 2017 to Foxtech K130 with Pixhawk

2 Feb 16, 2017
Reply by Maxim

"3.2.1 is the last version that is supported on APM hardware. Anything higher needs P…"

Craig replied Feb 16, 2017 to Cannot download APMCopter V3.4.5 via Mission Planner

4 Feb 16, 2017
Reply by Jerald Thompson

"format the SD Card and see if your issue goes away."

Craig replied Feb 8, 2017 to What is this error sound coming from Pixhawk 1?

6 Feb 10, 2017
Reply by Chad Frazer

"There are 3 flight modes you could look at. Stab is just pretty much auto level that…"

Craig replied Jan 4, 2017 to Stabilize mode like Loiter mode !!!

2 Jan 4, 2017
Reply by Ewing Kang

"open MP and without connecting go to config/tuning and check the layout/advanced fro…"

Craig replied Dec 20, 2016 to Mission Planner 1.3.42 no Full Parameters List

6 Jan 23, 2017
Reply by Graham Dyer

"do NOT forget to use a cord to tie the 2 tubes together. I had a bud forget when he…"

Craig replied Nov 30, 2016 to Pixhawk Shuts down when elevator or Aileron is used

19 Dec 8, 2016
Reply by Tim H

"yah it's a tad small for my T960 too lol. Like I said I made it a few years ago when…"

Craig replied Nov 30, 2016 to Pixhawk Shuts down when elevator or Aileron is used

19 Dec 8, 2016
Reply by Tim H

"I built a stand a few years ago to "air test" units without actually having them in…"

Craig replied Nov 30, 2016 to Pixhawk Shuts down when elevator or Aileron is used

19 Dec 8, 2016
Reply by Tim H

RSS

© 2018   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service