Ben's Discussions (40)

Discussions Replied To (24) Replies Latest Activity

" Yeah, you could run it on Ardumega, as that is the base chip on the ardupilot. The…"

Ben replied Sep 8, 2016 to Arduino Boat

12 Sep 9, 2016
Reply by Andy Fabian

"you should be able to ardupilot and set auto navigation to way points, I think that…"

Ben replied Sep 5, 2016 to Arduino Boat

12 Sep 9, 2016
Reply by Andy Fabian

"Yeah, there's a great video by these guys thas show to waterproof electronics for IP…"

Ben replied Sep 5, 2016 to Water drone application

4 Jun 20, 2017
Reply by christopher.shiny

"Under logs there CURR and Vcc,"

Ben replied Jun 11, 2015 to Quad flipped upside down in Loiter mode

3 Jun 11, 2015
Reply by Ben

"have you tried changing the mix between baro and gps 3d fix? "

Ben replied Jun 10, 2015 to Altitude Hold Troubleshooting

4 Jun 10, 2015
Reply by Ben

"Have you tried recalibrating your brushless gimbal controller down on the P setting?…"

Ben replied Jun 10, 2015 to Would someone take a look at my logs please

1 Jun 10, 2015
Reply by Ben

"Test: IMU Mismatch = GOOD - (Mismatch: 0.26, WARN: 0.75, FAIL: 1.50) Test: Compass =…"

Ben replied Jun 10, 2015 to quadcopter motors 2&3 spinning faster than 1&4 resulting in tip over at take-off

4 Jun 25, 2015
Reply by Rudy

"Auto Analysis says "Test: VCC = FAIL - VCC below minimum of 4.6v (4.417v)" It crashe…"

Ben replied Jun 10, 2015 to Quad flipped upside down in Loiter mode

3 Jun 11, 2015
Reply by Ben

"Your battery voltage spiked and then fell below 11v as the EKF fail safe error check…"

Ben replied Jun 10, 2015 to Help! Explain this log to me?

6 Jun 10, 2015
Reply by Ben

"what are your failsafes set to? and is there any type of transmission antennas with…"

Ben replied Jun 9, 2015 to I just want to know what happened...

4 Jun 21, 2015
Reply by Michael

RSS

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service