Steve's Discussions (18)

Discussions Replied To (13) Replies Latest Activity

"I use the Ardupilot codebase in a university setting. I personally found the Ardupil…"

Steve replied Jan 30, 2017 to Should I use PX4 flight control stack or the APM 3.3 for Pixhawk?

11 Jan 30, 2017
Reply by Steve

"I need to double check but I think its a 4S5P pack so 17000 mah @ 2C rating(at most)…"

Steve replied Apr 14, 2016 to Autotune successfull on low kv Motors, heavier Quads, advice?

48 Aug 2, 2016
Reply by Matt Greenway

"Thank you! I will have to confirm my pixhawk's are both up to date. I was fairly cer…"

Steve replied Apr 14, 2016 to Autotune successfull on low kv Motors, heavier Quads, advice?

48 Aug 2, 2016
Reply by Matt Greenway

"Thanks Henry for looking Couple things - I'm fairly certain on the loiter the throt…"

Steve replied Apr 14, 2016 to Autotune successfull on low kv Motors, heavier Quads, advice?

48 Aug 2, 2016
Reply by Matt Greenway

"I followed steps on the wiki for setting thr mid and all other needed calibrations.…"

Steve replied Apr 13, 2016 to Autotune successfull on low kv Motors, heavier Quads, advice?

48 Aug 2, 2016
Reply by Matt Greenway

"Did you have to change your throttle gains much to get alt-hold to work? I am havin…"

Steve replied Apr 11, 2016 to Autotune successfull on low kv Motors, heavier Quads, advice?

48 Aug 2, 2016
Reply by Matt Greenway

"I'd recommend building the UART_test in /ardupilot/libraries/AP_HAL/examples/UART_te…"

Steve replied Sep 16, 2015 to How to output PWM values from UART of PX4 via BeagleBone while using ArduPilot code

5 Sep 18, 2015
Reply by Sj

"This is the error I get after putting the bootloader back on and after I did a stand…"

Steve replied Sep 9, 2014 to What causes Bootloader Failure?

1 Sep 9, 2014
Reply by Steve

"Hey Oliver I struggled with this for awhile too. your wiring looks correct but as s…"

Steve replied Aug 14, 2014 to APM PPM from openlrsng

15 Sep 5, 2014
Reply by Thierry Ligeon

"What are you running ardupilot (2.5-2.6) or pixhawk?  I think highres imu might not…"

Steve replied Jul 10, 2014 to How to read acceleration from APM using mavlink (c++)?

19 Apr 25, 2017
Reply by Fernando Lima Saraiva Filho

RSS

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service