u4eake's Discussions (458)

Discussions Replied To (430) Replies Latest Activity

"I have also upgraded to 2.0.33 today and can confirm the findings from druckgott. Al…"

u4eake replied Jul 5, 2011 to 2.0.33 works very well in Loiter mode. Circle of 1 meter

19 Jul 9, 2011
Reply by marcelo

"Can the loiter radius be set to zero ? Or would that introduce nasty division by zer…"

u4eake replied Jul 5, 2011 to Can someone PLEASE share their Loiter PID's.

41 Jul 8, 2011
Reply by Peter

"Why are values grey : because in the upper right corner of your attached picture, yo…"

u4eake replied Jun 30, 2011 to Help!!! Arducopter goes wild

30 Sep 11, 2011
Reply by heckmic

"That's a neat looking switchbox and a good solution if your tx doesn't support the p…"

u4eake replied Jun 29, 2011 to The ultimate modeswitch for my FF6

5 Jul 28, 2011
Reply by roger

"I have the same problem, is the cause known already ? Any fix available ?"

u4eake replied Jun 26, 2011 to Arducopter 2.0.26

14 Jun 27, 2011
Reply by Limebear (Rob)

"I actually have quite a bit of fan experience from flying and building ducted fan je…"

u4eake replied Jun 24, 2011 to Quadcopter / Arducopter with Ducted Fans

3 Jun 24, 2011
Reply by Rui Manuel Cravo Marques

"I agree and also had the hexa take off 2x unintentionally. Arming motors should only…"

u4eake replied Jun 18, 2011 to Can you arm the system when in RTH or other auto modes?

3 Jun 18, 2011
Reply by u4eake

"There are functions in the ACM2.0.23 code to switch the relay. They are called relay…"

u4eake replied Jun 13, 2011 to relay in ACM 2.XXX

9 Feb 2, 2012
Reply by Piero Angelucci

"I see you flew the quad with ardupirates before... I had the same issue with my hexa…"

u4eake replied Jun 11, 2011 to Flip on takeoff

15 Jun 12, 2011
Reply by Eoin

"Yes and channel 6 can be used to manually tilt the camera.  You must make sure it's…"

u4eake replied Jun 10, 2011 to Camera Stabalization on AC 2.0

1 Jun 10, 2011
Reply by u4eake

RSS

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service