Max Patissier's Discussions (89)

Discussions Replied To (73) Replies Latest Activity

"thank you for you advice Emin. We get this one : http://www.readytoflyquads.com/rtf-…"

Max Patissier replied Sep 13, 2016 to Pixhawk apparently losing ESC calibration data

16 Dec 13, 2016
Reply by Chris Hardwick

"we have the same behavior : with APM series, ReadytoFly ESC 30A work very well. With…"

Max Patissier replied Sep 12, 2016 to Pixhawk apparently losing ESC calibration data

16 Dec 13, 2016
Reply by Chris Hardwick

"bravo les gars !"

Max Patissier replied Sep 12, 2016 to Tuning parameters for thermals

16 Sep 22, 2016
Reply by Jean-Jacques

"we are working on it..... the idea is to have radio link in the country and use it a…"

Max Patissier replied Jun 30, 2016 to WiFi Telemetry with Cheap ESP8266

11 Mar 31, 2018
Reply by Alexey Dobrovolskiy

"we change RC3 from 880 to 867. The problem is almost gone but I still do not underst…"

Max Patissier replied Apr 13, 2016 to Motor still running after disarm (when motors or ESC are hot)

3 Apr 13, 2016
Reply by Max Patissier

"tip : try also with AltHold and Loiter. Vibrations usually are low at stab mode."

Max Patissier replied Apr 13, 2016 to Vibrations 3.3

4 Apr 21, 2016
Reply by Mikko Korhonen

"yes. Start at 0.15 and I bet that you will not be below 0.14"

Max Patissier replied Apr 12, 2016 to Pixhawk with low KV motors unstable/crash

15 Nov 29, 2016
Reply by Emin Bu

"yes. Start en Stabilize, and when it look good, Alt Hold and Loiter. We get once thi…"

Max Patissier replied Apr 12, 2016 to Pixhawk with low KV motors unstable/crash

15 Nov 29, 2016
Reply by Emin Bu

"hi, what is your drone configuration ? motor ? Propeller ? Battery ?"

Max Patissier replied Apr 12, 2016 to Drone lands automatically soon after take-off

2 Apr 18, 2016
Reply by Sj

"what kind of ESC are you using ? Look like a ESC desynchronization when the UAV goes…"

Max Patissier replied Apr 12, 2016 to Pixhawk with low KV motors unstable/crash

15 Nov 29, 2016
Reply by Emin Bu

RSS

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service