Alan D's Discussions (76)

Discussions Replied To (74) Replies Latest Activity

"Joel, Depending on where you are, I have a 450 size quad with Naza, GPS, OSD, camer…"

Alan D replied Jun 19 to Building a Drone from scratch

7 Jun 22
Reply by Joel McCoy

"Is there foam over the baro sensor inside the pixhawk case? If it is missing it coul…"

Alan D replied Jun 3, 2015 to hexacopter bobbles up/down on pitch when flying headwind - Pixhawk

3 Jun 10, 2015
Reply by Ivan R

"Not sure what gimbal you're using, but I had similar with my Tarot gimbal, which I e…"

Alan D replied Jan 14, 2015 to I've got the shakes! Any tips?

2 Jan 14, 2015
Reply by astroknut

"I've not looked at your log yet, but spinning suggests a motor / ESC failure or poor…"

Alan D replied Jan 14, 2015 to Large Hexa w/3.2 Crash Log

4 Jan 14, 2015
Reply by Alex

"You need 2 of each. Agree that Hubsan X4 motors should work. Check the diameter, as…"

Alan D replied Jan 9, 2015 to Motor broken on my Quadcopter

4 Jan 9, 2015
Reply by Alan D

"Have you got a power module? Is it configured in the APM setup? Without both the APM…"

Alan D replied Jan 6, 2015 to Stablilize Mode Question

12 Jan 19, 2015
Reply by Bill Kiskin

"Can you swap that motor to another position, then same for the ESC - should quickly…"

Alan D replied Dec 8, 2014 to Determining if esc/motor/or ? is bad

2 Dec 8, 2014
Reply by L

"Can you use a separate 5.8ghz video transmitter and a 'conventional' screen with a R…"

Alan D replied Nov 27, 2014 to Dji vision changing the camera to gopro

2 Nov 28, 2014
Reply by Christoph

"Try connecting the gimbal tilt input directly to a spare channel on the receiver, NO…"

Alan D replied Nov 24, 2014 to Tarot gimbal jitter

4 Nov 24, 2014
Reply by Alan D

"I had a similar issue on my hex, which was caused by a faulty ESC, on the side it fl…"

Alan D replied Jul 23, 2014 to APM 3.1 Wild Auto take off followed by crash

6 Jul 23, 2014
Reply by Alan D

RSS

Groups

Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service