Ultrafuge's Discussions (181)

Discussions Replied To (145) Replies Latest Activity

"Hi Benoit, could you please upload the modified files (sumd.c, sumd.h) and your wor…"

Ultrafuge replied Nov 28, 2016 to How do you use Graupner SUMD with Pixhawk ?

27 Dec 22, 2016
Reply by Benoît

"Hi, maybe you should try to set ALL of the CH.._OPT = 0 and DISARM_DELAY = 0. "

Ultrafuge replied Nov 4, 2016 to Pixhawk: Motor Interlock Enabled

3 Nov 4, 2016
Reply by Ultrafuge

"For me Pixhawk only was o.k. solution, but I always liked the behaviour of my FBL sy…"

Ultrafuge replied May 14, 2016 to Basic setup for Pixhawk + FBL

6 May 14, 2016
Reply by zhangpengsir

"Sorry haven't yet tried SBUS, but Tridge used it."

Ultrafuge replied May 14, 2016 to Basic setup for Pixhawk + FBL

6 May 14, 2016
Reply by zhangpengsir

"Common mistake would be wrong orientation... If your external compass is in a non-st…"

Ultrafuge replied May 11, 2016 to GPS distance from PIXHAWK/CG

9 May 15, 2016
Reply by Robert Hoermann

"Hi, rule #1 is to use 'Full parameter list / tree' and check every input after 'Refr…"

Ultrafuge replied Feb 24, 2016 to Need help on getting channel 8 to a RSC Mode

1 Feb 24, 2016
Reply by Ultrafuge

"No matter if I use Futaba or Graupner, I don't have any weird procedure arming the h…"

Ultrafuge replied Feb 8, 2016 to Any cons to reversing RC3 via parameter settings in MP?

1 Feb 8, 2016
Reply by Ultrafuge

"yes"

Ultrafuge replied Feb 8, 2016 to Swash plate angle question

2 Feb 8, 2016
Reply by Mark Van Haze

"Hi, I made one flight today with : H_FLYBAR_MODE = 1 and H_TAIL_TYPE = 1 ......usin…"

Ultrafuge replied Jan 27, 2016 to AC3.3 TradHeli Release Discussion

334 Sep 26, 2016
Reply by Craig Elder

"HS4_MAX,1700HS4_MIN,1300HS4_TRIM,1500 if these are really your limits, than this ind…"

Ultrafuge replied Jan 20, 2016 to AC3.3 TradHeli Release Discussion

334 Sep 26, 2016
Reply by Craig Elder

RSS

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service