Hein's Discussions (16)

Discussions Replied To (14) Replies Latest Activity

"Put in a temporary jumper to fix so I can continue testing with the software. It obs…"

Hein replied Jul 29, 2010 to Only 0 values from APM_ADC_test

14 Feb 25, 2011
Reply by John Erickson

"@Chris The issue was with the main ArdupilotMega board, one of the connector pin ho…"

Hein replied Jul 28, 2010 to Only 0 values from APM_ADC_test

14 Feb 25, 2011
Reply by John Erickson

"@Chris @Thomas Using Arduino IDE (v 0018) to monitor the output. Back to basics, Ch…"

Hein replied Jul 17, 2010 to Only 0 values from APM_ADC_test

14 Feb 25, 2011
Reply by John Erickson

"@Thomas that is the code I am using, it is the same as the one listed in my post"

Hein replied Jul 17, 2010 to Only 0 values from APM_ADC_test

14 Feb 25, 2011
Reply by John Erickson

"@Chris the board is powered from USB"

Hein replied Jul 17, 2010 to Only 0 values from APM_ADC_test

14 Feb 25, 2011
Reply by John Erickson

"Found a good reference discussion here : http://www.kansasflyer.org/index.asp?nav=Av…"

Hein replied Jun 18, 2010 to Pressure at speed (+head wind) - kPa / psi

4 Jun 18, 2010
Reply by Tom Yochum

"@tom Should really have looked that up myself :) So a max 2 kPa sensor should be g…"

Hein replied Jun 18, 2010 to Pressure at speed (+head wind) - kPa / psi

4 Jun 18, 2010
Reply by Tom Yochum

"@Ron Some more photos of the standard servo and receiver location below. The sides…"

Hein replied Jun 11, 2010 to PARKZONE Radian

12 Jun 11, 2010
Reply by Ron Jacobs

"The one I currently use, as you can see slightly skew. Strange thing is the more glu…"

Hein replied Jun 10, 2010 to PARKZONE Radian

12 Jun 11, 2010
Reply by Ron Jacobs

"@Ron the rough measurements are as follows : Length of main compartment : 13cm (bac…"

Hein replied Jun 10, 2010 to PARKZONE Radian

12 Jun 11, 2010
Reply by Ron Jacobs

RSS

© 2020   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service