OG's Discussions (431)

Discussions Replied To (395) Replies Latest Activity

"yes you have a problem if you disable pre-arm checks & you try to arm the craft …"

OG replied Jan 8 to Pixhawk 4 will not ARM

6 Jan 10
Reply by Thomas Butler

"I strongly suggest you pay a professional to build and setup your pixhawk drone if y…"

OG replied Jan 8 to pixhawks DEAD don't buy

9 Jan 11
Reply by Jed Smith

"DJI and PIX hawk are very different your comparing apples to oranges one is a closed…"

OG replied Jan 8 to pixhawks DEAD don't buy

9 Jan 11
Reply by Jed Smith

"Experience Is bold & stupid ? With Experience comes knowledge! In my Experience…"

OG replied Jan 8 to pixhawks DEAD don't buy

9 Jan 11
Reply by Jed Smith

"this is usually caused by user error ! GPS signal interference RC radio interference…"

OG replied Jan 8 to pixhawks DEAD don't buy

9 Jan 11
Reply by Jed Smith

"Just disable pre arm checks "

OG replied Jan 8 to Pixhawk 4 will not ARM

6 Jan 10
Reply by Thomas Butler

"have you tried carbon fiber reinforced filament ? http://brushlessgimbal.ca/3D-Print…"

OG replied Dec 30, 2018 to

just now

"Pix hawk is not easy if your not going to read and follow the instructions to the le…"

OG replied Dec 29, 2018 to Drone Help

7 Dec 29, 2018
Reply by Sbaksh

"you may want to look at DJI N3 or A4 this are the newer FC from DJI !"

OG replied Dec 29, 2018 to Drone Help

7 Dec 29, 2018
Reply by Sbaksh

"That is very old as well 8 bit technology ! if your doing photo work it is ok it wor…"

OG replied Dec 29, 2018 to Drone Help

7 Dec 29, 2018
Reply by Sbaksh

RSS

Groups

Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service