Richard Hirst's Discussions (11)

Discussions Replied To (8) Replies Latest Activity

Developer

"Hi Randy, thanks for the reply.. i did find it in the end but had to compile the cod…"

Richard Hirst replied Aug 14, 2012 to ArduCopter 2.7.1 Released

443 Jan 22, 2014
Reply by Kapinjal Vaidya

Developer

"HI.. could you pleae tell me if'  "'Instant PWM" is coded into the current release..…"

Richard Hirst replied Aug 11, 2012 to ArduCopter 2.7.1 Released

443 Jan 22, 2014
Reply by Kapinjal Vaidya

"Ok thanks.. will try it in the morning.    "

Richard Hirst replied Nov 14, 2011 to EXport Raw data

5 Nov 14, 2011
Reply by James

"Not sure what the tlog is..? The data that is sent via the telemetry, roll, pitch, y…"

Richard Hirst replied Nov 14, 2011 to EXport Raw data

5 Nov 14, 2011
Reply by James

Developer

"Hi Randy   I have CNC router I can cut the carbon sheet.. Down in OZ if it helps   R…"

Richard Hirst replied Aug 24, 2011 to Anybody know of a company that can cut carbon fibre plates cheaply?

26 May 25, 2013
Reply by Euan Ramsay

"I would look at an Electro-Magnet to hold the lid shut, then remove the current thro…"

Richard Hirst replied Nov 4, 2010 to DroneChute

24 Nov 24, 2013
Reply by Milind Pariwakam

"This is the part I used from Farnell TEXAS INSTRUMENTS Farnell Order Code: 1750389…"

Richard Hirst replied Sep 29, 2010 to Output died on MUX

15 Jan 25, 2013
Reply by Mark Grennan

"Hi Alex I had the same on ch2, sorted out the input and output till I found a repla…"

Richard Hirst replied Sep 29, 2010 to Output died on MUX

15 Jan 25, 2013
Reply by Mark Grennan

RSS

© 2020   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service