Andy Baker's Discussions (23)

Discussions Replied To (12) Replies Latest Activity

"One more question; other than yaw control, and protection against motor failure, is…"

Andy Baker replied Jul 7, 2016 to X8 prop layout and control

3 Jul 7, 2016
Reply by Andy Baker

"Thanks - that's exactly what I needed confirming - it does mean I need to think a lo…"

Andy Baker replied Jul 7, 2016 to X8 prop layout and control

3 Jul 7, 2016
Reply by Andy Baker

"I was about to ask the same question, so I'll share what _I_ think, and hope someone…"

Andy Baker replied Dec 12, 2015 to Compass sensor "IMU"

1 Dec 12, 2015
Reply by Andy Baker

"OK, I did a little more testing: Setting the gyro DLPF to 0, the ADC sampling rate g…"

Andy Baker replied Oct 6, 2015 to MPU9250 SMPLRT_DIV and DLPF_CFG data ready interrupt

1 Oct 6, 2015
Reply by Andy Baker

"Thanks Phillip, useful background I'll have a go with trying higher frequency dlfp…"

Andy Baker replied Dec 19, 2014 to MPU6050 deadzone around 0g?

5 Dec 19, 2014
Reply by Andy Baker

"One (unrelated) questions?  Why set dlpf as high as 250Hz?  I'd always assumed that…"

Andy Baker replied Dec 18, 2014 to MPU6050 deadzone around 0g?

5 Dec 19, 2014
Reply by Andy Baker

"Thanks Phillip, I tried pointing X and Y axes down, and they did show 1g as expecte…"

Andy Baker replied Dec 18, 2014 to MPU6050 deadzone around 0g?

5 Dec 19, 2014
Reply by Andy Baker

"Thanks Tom for the really clear answer.  My background is in physics, electronics an…"

Andy Baker replied Nov 26, 2013 to Prop size matching motor size / power?

2 Nov 26, 2013
Reply by Andy Baker

"Thanks for the extra advise - I'll bear it all in mind.  Not sure whether I'll need…"

Andy Baker replied Nov 23, 2013 to Running 2 'identical' batteries in parallel

13 Jan 17
Reply by Thomas Butler

"Thanks Guys - the fact it's done all the time is what I wanted to hear - I know just…"

Andy Baker replied Nov 23, 2013 to Running 2 'identical' batteries in parallel

13 Jan 17
Reply by Thomas Butler

RSS

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service