William millette's Discussions (13)

Discussions Replied To (10) Replies Latest Activity

Developer

"Figured it out... You must type in each command at the prompt.... There is no button…"

William millette replied Jan 25, 2013 to ArduCopter 2.9 / 2.9.1 released

3738 May 7, 2014
Reply by Hangingpixels

Developer

"Im updating mission planner now... Now have 1.2.32 mav1.0 So where now?"

William millette replied Jan 25, 2013 to ArduCopter 2.9 / 2.9.1 released

3738 May 7, 2014
Reply by Hangingpixels

Developer

"Im sory ive been trying to find the reset everywhere all over mission planner and i…"

William millette replied Jan 25, 2013 to ArduCopter 2.9 / 2.9.1 released

3738 May 7, 2014
Reply by Hangingpixels

Developer

"where can i find 2.9 stock settings? i tried reloading firmware but it keeps my old…"

William millette replied Jan 25, 2013 to ArduCopter 2.9 / 2.9.1 released

3738 May 7, 2014
Reply by Hangingpixels

"found my fix.... when the apm reconnects you go to device manager and install new dr…"

William millette replied Jan 23, 2013 to Apm 2.5+ with futaba T8J and 8ch futaba Reciever glitches, difficult arming,and out of control some times.

5 Jan 23, 2013
Reply by William millette

Moderator

"update...i found the dfu driver and installed it myself and now can connect to flipa…"

William millette replied Jan 23, 2013 to Is it necessary to (update)flash the Atmega32U2 (PPM encoder) on an APM 2.5 if using a Futaba system?

51 Aug 19, 2013
Reply by Elwyn Boykin

Moderator

"i purchased 2 new apm 2.5+ units from 3dr store last week.... everything was install…"

William millette replied Jan 23, 2013 to Is it necessary to (update)flash the Atmega32U2 (PPM encoder) on an APM 2.5 if using a Futaba system?

51 Aug 19, 2013
Reply by Elwyn Boykin

"Update... The apm on table watching gimbal shows the ghost glitch im experiencing oc…"

William millette replied Jan 21, 2013 to Apm 2.5+ with futaba T8J and 8ch futaba Reciever glitches, difficult arming,and out of control some times.

5 Jan 23, 2013
Reply by William millette

"I have lowered the hz to 20 to make sure and isolated apm on foam"

William millette replied Jan 20, 2013 to Apm 2.5+ with futaba T8J and 8ch futaba Reciever glitches, difficult arming,and out of control some times.

5 Jan 23, 2013
Reply by William millette

"Yes these purchased last week from diy drones in ca"

William millette replied Jan 20, 2013 to Apm 2.5+ with futaba T8J and 8ch futaba Reciever glitches, difficult arming,and out of control some times.

5 Jan 23, 2013
Reply by William millette

RSS

Groups

Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2020   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service