Dan Stevens's Discussions (32)

Discussions Replied To (32) Replies Latest Activity

Developer

"Does any one have any ideas?"

Dan Stevens replied Jul 30, 2013 to ArduCopter-3.0.1 released!

5021 Feb 18, 2016
Reply by Andrew A

Developer

"Been out flying today with my octo, luckily I had my laptop with me as the APM 2.5 l…"

Dan Stevens replied Jul 27, 2013 to ArduCopter-3.0.1 released!

5021 Feb 18, 2016
Reply by Andrew A

Developer

"Looked at these awhile ago but wasn't sure how to interface them both with the Ardup…"

Dan Stevens replied Jul 13, 2013 to ArduCopter-3.0.1 released!

5021 Feb 18, 2016
Reply by Andrew A

Developer

"I'm using the Hitec Aurora system with 9ch rx, will have to have a look at there tel…"

Dan Stevens replied Jul 13, 2013 to ArduCopter-3.0.1 released!

5021 Feb 18, 2016
Reply by Andrew A

Developer

"Hi Oliver, which current sensor would you recommend for heavy lift octos? I'm using…"

Dan Stevens replied Jul 13, 2013 to ArduCopter-3.0.1 released!

5021 Feb 18, 2016
Reply by Andrew A

Developer

"It was reset and erased the other day, then 3.0.1rc1 was loaded on to it. Did all th…"

Dan Stevens replied Jul 12, 2013 to ArduCopter-3.0.1 released!

5021 Feb 18, 2016
Reply by Andrew A

Developer

"Hi Craig, I did that and now it's level again. Any idea why it lost level? Roll and…"

Dan Stevens replied Jul 12, 2013 to ArduCopter-3.0.1 released!

5021 Feb 18, 2016
Reply by Andrew A

Developer

"update: re installed .59 and the hud is still the same. Any one have an idea why th…"

Dan Stevens replied Jul 12, 2013 to ArduCopter-3.0.1 released!

5021 Feb 18, 2016
Reply by Andrew A

Developer

"Hi, managed to get my octo flying yesterday on this latest firmware. Today ive just…"

Dan Stevens replied Jul 12, 2013 to ArduCopter-3.0.1 released!

5021 Feb 18, 2016
Reply by Andrew A

"My plan is to add the New 3DR GPS with built in mag when it comes to the UK. Probabl…"

Dan Stevens replied Jul 12, 2013 to Ardupilot Mega - Any good for larger multi-copter frames?

35 Oct 27, 2013
Reply by Henri

RSS

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service