13brv3's Discussions (58)

Discussions Replied To (50) Replies Latest Activity

3D Robotics

"Chris, I think one of the requirements for a DIY Drones platform should be "Arduino…"

13brv3 replied Apr 26, 2010 to Which Quadcopter should we adopt?

75 Sep 1, 2010
Reply by Ted

3D Robotics

"Hi Chris, Glad that worked. The UDB outputs pulses at a slower rate than the receiv…"

13brv3 replied Mar 7, 2010 to Discussion forum for UAVDevBoard, Sparkfun's 3-axis IMU-based autopilot board

706 Jul 24, 2013
Reply by Charles lakins

3D Robotics

"Hi Chris, I use the Turnigy Plush ESCs (18A and 30A) with the UDB, so I know they w…"

13brv3 replied Mar 7, 2010 to Discussion forum for UAVDevBoard, Sparkfun's 3-axis IMU-based autopilot board

706 Jul 24, 2013
Reply by Charles lakins

3D Robotics

"Hi Pete, I'm not sure what 4 pin connector your referring to, but for something exp…"

13brv3 replied Mar 2, 2010 to Discussion forum for UAVDevBoard, Sparkfun's 3-axis IMU-based autopilot board

706 Jul 24, 2013
Reply by Charles lakins

3D Robotics

"Hi Bill, In my opinion, not offering an upgrade board would be a very unpopular dec…"

13brv3 replied Mar 2, 2010 to Discussion forum for UAVDevBoard, Sparkfun's 3-axis IMU-based autopilot board

706 Jul 24, 2013
Reply by Charles lakins

3D Robotics

"Hi Bill, Hopefully, SparkFun can make these boards available for people to upgrade…"

13brv3 replied Mar 2, 2010 to Discussion forum for UAVDevBoard, Sparkfun's 3-axis IMU-based autopilot board

706 Jul 24, 2013
Reply by Charles lakins

3D Robotics

"I'm assuming those new gyros are retrofitted to the current board? If so, will that…"

13brv3 replied Mar 2, 2010 to Discussion forum for UAVDevBoard, Sparkfun's 3-axis IMU-based autopilot board

706 Jul 24, 2013
Reply by Charles lakins

"For the FASST 6 and 7 channel receivers, you can solder a wire inside to get the fir…"

13brv3 replied Jan 30, 2010 to Futaba FASST Receivers, and connection to ATMega, ArduPilot etc.

7 May 5, 2010
Reply by Richard Brown

3D Robotics

"Hi Ric, I started out using crosstracking since it was the default, but it was obvi…"

13brv3 replied Oct 27, 2009 to Discussion forum for UAVDevBoard, Sparkfun's 3-axis IMU-based autopilot board

706 Jul 24, 2013
Reply by Charles lakins

3D Robotics

"Hi Bill, I wasn't that worried about it. I've got a bench full of ways to connect t…"

13brv3 replied Oct 26, 2009 to Discussion forum for UAVDevBoard, Sparkfun's 3-axis IMU-based autopilot board

706 Jul 24, 2013
Reply by Charles lakins

RSS

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service