All Discussions Tagged '2.8' (15)

Discussions Replies Latest Activity

APM Won't Arm, Disabled all safety's Still won't Arm

Running APM 2.8 Arducopter V3.2.1 Everything was running fine until a moter started running rough and caused a small crash, so I replaced a…

Started by Alan

0 Apr 27

APM 2.8 with rover2.51(Beta) directly going to 'Hold Armed' in QGroundControl

Hi, In my APM 2.8 whenever I try to connect to QGroundControl through USB or through telemetry, it's directly going to Armed state, so I'm…

Started by Bibin Wilson

0 Aug 6, 2018

Which version of Arducopter to use with an APM 2.8 FC?

Copter= 550 mm Hex, FC= Arducopter APM 2.8, TX= Turnigy TGY 9X, RX= Turnigy 9X8C V2, Motors= Turnigy Prop-Drive 28-26 1200 KVa, Props= 9" S…

Started by Jerald Thompson

0 Feb 1, 2017

Camera trigger / relay output for DSLR

I am using the latest software and an APM 2.8. All I need is the relay out put from APM to go from 0v to 5v when I activate a switch on my…

Started by Bob Smith

0 Jan 11, 2017

PLEASE HELPME !!!. I am trying to compile ArduCopter Code for APM 2.8

Please from Argentina, I can not compile and upload any code, if someone has Arduino code and Arduino version that you can reference I than…

Started by Victor Peñalver

0 Nov 17, 2016

ESC won't calibrate to APM unless the lower throttle is 900.

Hello everybody. I have an APM 2.8 with Emax ESC 30A Blheli. And there's the problem. At the beginning, when ESCs were connected to RX on m…

Started by Grzegorz Radziwiłko

8 Oct 17, 2016
Reply by Grzegorz Radziwiłko

APM 2.5 GPS connection sockets vs APM 2.6 and APM 2.8 GPS connection spclets

I have an Arducopter APM 2.5 Flight Controller that is giving me compass trouble and I ordered two APM units to replace it.  Neither of the…

Started by Jerald Thompson

0 Oct 5, 2016

APM 2.8 - QUAD Copter - ESC 30A, 2212 MOTORS

Hello Everyone, I've been browsing the forums for awhile now, learning and lurking as they say. I purchased a quad copter kit from Amazon…

Started by Gus Gunderson III

3 Aug 30, 2016
Reply by Gus Gunderson III

Strange apm 2.8!!!!

I recently bought a new apm 2.8 with neo 6m gps module and i configured using mission planner 1.3.39.1 build 1.1.6056.17827 and with versio…

Started by Aryamann Sharma

29 Aug 7, 2016
Reply by Craig

HELP - Rangefinder with APM 2.8 running 3.4 for autoland

Hi, I'm just starting with  ARDUPLANE - I have managed to get my HK Sky Eye working well with Pan/Tilt FPV and APM 2.8 running 3.4. I now…

Started by ian nash

0 Jul 11, 2016

RSS

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service