All Discussions Tagged 'ardurover' (9)

Discussions Replies Latest Activity

Pozyx + ArduRover Integration

Hi,  I wanted to know if someone has tried an indoor localisation for Ardurover the way it has been done for Arducopter here: http://ardupi…

Started by Raghavv Goel

1 Aug 27, 2018
Reply by Raghavv Goel

poor link quality RFD 868+ regardless high RSSI/low noise and no RXerrors

Hi all, I am using a pixhawk and ardurover (v3.01) to control a RC boat.  I am using mission planner v1.3.41 using an RFD 868+ set to link…

Started by Thijs

0 Oct 20, 2016

Swapping out GPS for custom localization method

Hello all! I am very, very new to Mission Planner (with a device currently configured with ArduRover). My question is whether or not it wou…

Started by Gordon Keller

0 Jun 24, 2015

ESC's on rover calibrate perfectly separately, but don't work together

On my rover, the speed controllers calibrate well one by one, but together they seem to throw each other off. The throttle ranges get screw…

Started by William Edds

0 Feb 3, 2015

Uses of Autonomous RC car

Hello there! I'm building my own car-drone, but lacking ideas.   Just wanted to know what could be this kind of drone used for? Any practic…

Started by YureZzZ

8 Mar 30, 2014
Reply by Al B

Delay between waypoints?

Is it possible to make delay between waypoints? I need this for my ArduRover mission. I saw screenshot with delay column in flight plan (at…

Started by Maciek

1 Mar 28, 2014
Reply by RoboBill

ArduRover vehicular platorm suggestions?

Hi all - So glad I found this group and forum. I've been interested in this topic for a couple years now. I've decided to start with an Ar…

Started by davefer

7 Feb 16, 2012
Reply by Thomas J Coyle III

ArduBoat? Help with first USV

Hello, hopefully this is in the right section, Im trying to convert a simple RC boat into a fully autopiloted vessel. Im under the impressi…

Started by Jonno Sintomac

2 Dec 16, 2011
Reply by Jonno Sintomac

QGroundControl "Uninitialized Mode"

Hi,   I'm trying to write waypoints to my APM board using QGC but I get the error "Operation timed out"   I think it's because QGC says my…

Started by Junior Sammy

13 Jun 18, 2011
Reply by Junior Sammy


© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service