All Discussions Tagged 'attopilot' (16)

Discussions Replies Latest Activity

Battery Monitor Works on Pixhawk 1 but not Pixhawk 2 Cube

I'm currently having issues with getting the battery monitor to work properly on my Pixhawk 2 Cube from ProfiCNC. I thought that perhaps I…

Started by Michael Dornisch

9 Jun 18, 2018
Reply by Frits

Attopilot 180A burn with DJI S1000

Hi, Today I had a major crash with a DJI S1000 with Pixhawk controller. The power module was an attopilot 180A. I was flying at about 30m w…

Started by Cristóbal Valdivieso

0 May 15, 2016

Attopilot 180 A, non linear voltage&current reading

Hello people! I'm having problems with my Attopilot 180A voltage and current sensor. I know people had similar problems but can't find any…

Started by Dean Hitrec

11 Nov 16, 2015
Reply by Hugues

High current sensing for power module

Why not use thread as shunt ?The power module use a 0.0005 shunt resitor for a mximum of 90 amperes.If we use the thread as shunt we can…

Started by Gerard Valade

0 Sep 21, 2015

AttoPilot Voltage and Current Sense or other options that are pre-wired?

Hello Total Pixhawk noob here. I have just completed building my first pixhawk controlled hexicopter, the DJI S900. I am looking at buildin…

Started by Ag Drone

0 Feb 15, 2015

Powering APM 2.5 board with Multistar ESC

I am trying to power an APM 2.5 in a 6S system so I am using an Attopilot voltage/current sensor but it doesn't power the board.  Can I pow…

Started by Parker Stephen

2 Jan 9, 2014
Reply by Parker Stephen

Apm 2.5 Power monitoring Issue

  Hi everyone;  I harmed my ardupilots battery sensor(for ATTO pilot pin A1,A2) pins accedientally. I want to change these pin to use again…

Started by Ufuk Irmak

4 Nov 23, 2013
Reply by Ufuk Irmak

AttoPilot Current Sensor Wrong Reading

Hi. I've just installed AttoPilot current and voltage sensor on my APM. On my plane, everything is powered from ONE battery. (Motor, APM, E…

Started by Derin Hakan Karakurt

1 Feb 6, 2013
Reply by Guzzi Adi

APM2.0 + Attopilot 90A wrong current reading

Installed Attopilot 90a on my apm2.0 voltages seem fine but current is way off, idle amp wooping 132A static with only battery connected, n…

Started by idzuwan

2 Feb 5, 2013
Reply by Bill Bonney

Current Sensor for APM 2.5 (170A)

I have a new build coming up that's an Octo that I'm planning on using http://www.foxtechfpv.com/tmotor-351515-kv400-motor-p-822.html with…

Started by Miles Smith

2 Dec 20, 2012
Reply by Miles Smith

RSS

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service