All Discussions Tagged 'signal' (16)

Discussions Replies Latest Activity

Nasty Crash due to GoPro Wifi Interference ?

Hi Guys, Recently had a nasty crash with my arduplane setup. It was Flying beautifully, however shortly after the last takeoff in Manual mo…

Started by Nicholas Matias

4 Mar 9, 2017
Reply by David L.

APM Rover Motor Driver using L2983D Dual H Bridge.

hello friends, i have built a 4 wheel driver Rover using a Aurdino Uno board with a L298D Dual H Bridge Motor Driver. i wish to replace t…

Started by Siddharth Shivalkar

3 Sep 1, 2016
Reply by Johar Palacita

Antenna Elbow - Reduce Signal Loss!

This is an antenna elbow that holds an antenna coax at 90 degrees or close to it. According to some sources, there is a slight signal loss…

Started by Harvcopter

0 Jan 21, 2016

Carbon Fiber frames bad for radio reception?

I understand carbon fiber can block radio signals.  However, I see a lot of carbon fiber frames out there.  Does CF block radio signals any…

Started by Haygood

3 May 21, 2015
Reply by Sam Arbizo

Writing Servo pwm signals through User-Hooks

Hello, I am currently trying to use User-Hooks to control a servo. I have a quadcopter and am using the pixhawk controller. However, I can…

Started by Juanjo Campuzano

1 Feb 20, 2015
Reply by Juanjo Campuzano

APM 2.5.2 isn't outputting a signal to servos

Hello, I'm having trouble with my new APM board. I have it all working and set up with Mission Planner. I can see the transmitter signals b…

Started by Mark Williams

6 Jan 25, 2014
Reply by Mark Williams

Auto mode APM 2.5 / Out of range TX/RX

What is the default setting when my quad is on mission with waypoints out of range for the transmitter. I've seen several discussion about…

Started by Lars-Erik Andersen

5 Dec 9, 2013
Reply by Lars-Erik Andersen

Arducopter 3.0.1 signal lost & flew away [with dataflash log+gpx+kmz]

Hi everybody, I had a terrible accident this tuesday. Before I get into detail, first I have to point out that antenna of my radio receiver…

Started by Ahmet YILDIRIM

2 Sep 27, 2013
Reply by Ahmet YILDIRIM

2 On-board Cameras

Hi My plan is to mount 2 cameras on my quadcopter. A Hero GoPro, for a front view, and a small Sony CCD camera for a rear view. I transmit…

Started by Tony Foate

3 May 27, 2013
Reply by Tony Foate

APM 2.5 3dr connection problems

Hello community, we've recently bought the APM 2.5 with the 3DR telemetry kit (433 MHz for Europe) but we now we are facing some problems.…

Started by Martin Schmid

1 Apr 29, 2013
Reply by Martin Schmid



Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service