All Discussions Tagged 'solder' (6)

Discussions Replies Latest Activity

Soldering motor cable

Hello, My problem is the following: I had an unfortunate crash and one of the cables of a motor (the red cable, which I suppose that is th…

Started by Óscar Moreno García

18 Sep 18, 2014
Reply by bill bergovoy

Soldering APM2.5+ Power module cables straight to PDB?

Gday guys,   I have a 3DR hexa kit, and was wondering if there is any practical reason that I am not seeing to use the xt-60 connectors on…

Started by daniel

3 Feb 13, 2013
Reply by daniel

Alternate way of connecting compass...?

Hi all, I recently purchased and have finally put together my Arducopter from Jdrones. My compass came with wires and plug attached but I…

Started by Luke Vierdag

1 Dec 23, 2011
Reply by Arnt-Inge Hansen

IMU lacks solder blob on 3 indicated locations..

We got a new IMU board as we've become skeptic of the data coming out of our previous IMU . Anyway, we've noticed that on our old imu, thes…

Started by Jonathan Diaz

3 Nov 6, 2011
Reply by Jonathan Diaz

Repairing HMC compass board

I managed to do something stupid while removing compass board from imu after crash. I was gently heating the pin ends which hold compass bo…

Started by Henri Siik

3 Aug 11, 2011
Reply by Henri Siik

Advice: Double check all ArduCopter kit motor leads for good solder joints.

Hello all, I had a problem where one of my motors would just twitch when throttle was applied. It was debugged here: http://www.diydrones.…

Started by Wes Cravens

1 Jun 21, 2011
Reply by Veljo Sinivee


© 2018   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service