3 Axis Synchronous Belt Drive Aerial PTZ Pan Tilt Zoom Camera Mount/

Hi all,

I am looking with interest this camera gimbal 3 axis

http://www.aliexpress.com/item/free-shipping-3-Axis-Synchronous-Bel...

my doubt are about servo and apm 2.5 firmware... they dont seems to be directly attacched but have a ratio of 1 to 5 .. so I'm wondering if I get change in 180/5 degrees or should I use rotary engines and place the pot on the larger disk

any idea or suggestion?

thanks

Views: 1499

Attachments:

Reply to This

Replies to This Discussion

Stefano,

Geared reduction on external, mutli-turn pots, on the final axis drive shaft, give excellent results, IMHO. There are some very precise antenna trackers out there using this with the APM for accurate positioning. You're definitely on the right path.

Hi,

I have just completed my build with the exact same gimbal
I'm planning on doing a buildlog on how I did it, since it was not straight forward.

As you probably have found out there is somewhere between little and no build-instructions.

The machining is also so and so, there is many parts which needed some adaptation before they could be used. I also found out that I had to strip it down to a 2-axis gimbal to get it steady enough.
Also I had to devise a way to get it to be a closed-loop controlled gimbal, because of the further downgearing you have to modify the servos both for multiturn and external potmeters. (APM also dont support angular rate based stabilization, just the absolute position (which is realy the only thing worth using))

One last thing is to get FAST servos, I was using 0.15 sec/60 servos. These were way to slow and I'm now waiting for 0,05 sec/60 servos.

thanks to all for advicing, I am still waiting the parcel  ... with parts on my hands i will start to find a solution ... if someone has should be useful photos about solution already found

Anders,

Can you please post some pictures? 

Thanks 

Reply to Discussion

RSS

Groups

Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service