Please guys i need some help. I got a pair of 433 MHz telemetry modules from RCTimer, but the antennas just don't perform. And i want to buy some new ones. I am thinking in buying one of this dipole for the Ground Starion and one of this to use in the Quad. Is this the best configuration? Please help me soon.

Views: 35562

Reply to This

Replies to This Discussion

If you do some research go check a bit at IBCrazy's blogs they have some good designs and documentation.

http://www.rcgroups.com/forums/member.php?u=103113

I am pretty sure that these little radios are actually capable of blowing themselves up when operated with the antenna disconnected.

I blew up my ground station radio not long ago, following a year of faultless operation.  The only thing I did differently to usual? I momentarily connected radio to my Nexus 7 prior to connecting the antenna.

Ground Station radio was 433Mhz HopeRF based RCTimer USB module.

Any transmitter operated without an antenna will have a SWR that will in all likeliness destroy it. Its why we have a dummy load that you connect when testing, to absorb the power. See http://en.wikipedia.org/wiki/Dummy_load

gents,  

try this on ebay.

search for   433 MHz handheld antenna.

and then change 433 MHz  for  70cm.

this is the wave lenght for 433MHz then you will find walkie talkie antennas which are used by hams.

these are great for your base station.  and if thats not enough, try to change "handheld" for "mobile "  for your base station.

youll need a sma to rp sma adapter or bnc to rpsma etc. 

Wilfred ON4NDO.

I was always told with antennas never to use connectors/adaptors if you can possibly avoid it, as it's the first port of call for noise/interference.  I was looking for ready made antennas with the correct connector already on there, but it seems near on impossible to find.

Which begs the question, why on earth does 3DR use this connector?  All the clones seem to use SMA which appears to be a lot more sensible!

A 1/4 must have a counterpoise, to simulate the full half wave. That is why it did not work. Easiest to do, cut a half wave dipole by this formula: 468/frequency in MHz. Some use other than 468, but it will get what you want.

Take a piece of coax, have a connector on one end for connection to your transmitter. Use the formula above. Strip the outside of the coax, careful not to cut the shield wire or middle conductor. Pull the metal shield down over the outside sheath, that is a half wave dipole antenna.

Attach it to your UAV in a manner that let's the antenna hang straight down. Use a Beam antenna for distance, Yagi, Quad, Gizmotchy all work very well.

The real issue is Standing Wave Ratio(SWR). The dipole described should provide an SWR of 1.5 to 1 or less.

There is no need for expensive antenas...I got this and since then I forgot problems with reception.....

http://www.goodluckbuy.com/rlink-long-range-receiver-antenna-standa...

EC unchecked, air speed 128 for no problems with uploading....

Thanks Emin - these look great! Can't wait to try them.

this are flexible(not too much, airflow cant flex them),if you need them stiff add 1 or 2 layers of heat shrink....

What range are you getting with these? Got any RSSI or NOISE figures?

Reply to Discussion

RSS

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service