Advice needed: how to mount a Raspberry pi camera module jello free?


I have build a small quadcopter which I want to use for low quality/high risk mapping tasks. Unfortunately the Raspberry Pi camera shows extreamly high jello, there are serveral horizontal stripes going through the picture.

Has anyone experience how to mount the camera? I have used some gel pads, but I guess the camera is to light.

Thx, Tobias

Views: 167

Reply to This

Replies to This Discussion

Howdy! How's your research so far? Found a trick to clear those horizontal stripes?

I will try to isolate the battery and the camera together against vibrations and hope the weight of the battery will do the job. I had not had the time to try it yet.

Hope you will get good results with the isolation. Appreciate any update

Reply to Discussion


© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service