Hello!
I'm new to the APM technology and i had recently purchased the APM 2.6 mega board.
While making the initial setup i uploaded the firmware hex file into the board. And was successful in configuring the Accelerometer too as it is showing me the readings on the flight data screen.
But i'm not able to calibrate my RC. I'm using a Futaba 7C transmitter and tried various compatible receivers.!!!
I have connected the outputs from the receiver to the apm board( which is externally powered by a LiPo), also I can see all lights on apm and receiver working correctly, yet the mission planner just doesn't show any fluctuation in the PWM readings of the RC.
Am i missing out any steps? Pls help.
PS: whenever i connect the receiver to the apm board(while connected to Mission Planner) is disconnects itself from the COM port. Thus i have to re-plug it in again,strange :(
Replies