After having replaced one esc that I burned because of a too hot soldering iron, APM arms but motor won't spin, except if I move the throttle stick up. When connected to MP, I have "system 1 is armed", but motors stay still. I can fly my copter, but I love this safety feature of APM 2 of seeing the motors spinning at min throttle. I changed MIN_THR_SPIN to different values, from 0 to 300, but it doesn't change. I also did the auto calibration of the esc, without success. What do you suggest? Am I missing something? Is it a way to reset the APM? I run on the mac version of mission planner, I didn't find the CLI. My PWM stay between 1100 to 1900 on all 4 axes.

Best regards,

Oscar

Views: 165

Reply to This

Replies to This Discussion

No one knows?

Reply to Discussion

RSS

Groups

Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service