apm1 3 of them just stop working!!!

Ok, I almost done with this, after 10 great flies with my skyfun jet, I just try to install my apm 1 with IMU board on one of my Quad and it did it again this is the no.3 apm board that suddenly stop working, the firts one stop to have signal input from the receiver , I replaced it, after many flies the second one just stop
conecting via usb no been able to load codes again the ATMEGA2560 stop working, now no3 just stop woking too all sensor are dead, all wired acoording to the manual, what is hapenning I doble everything help!!!!

Views: 177

▶ Reply to This

Replies to This Discussion


ModeratorPermalink Reply by John Church on January 31, 2012 at 8:57pm

Not good, Valentin! Got any pictures of your wiring? Maybe we can spot something that you missed.

Permalink Reply by valentin colon on February 1, 2012 at 7:06am

jhon I did recheck my wiring, any ways I will send you picture...thanks

▶ Reply to Discussion

RSS

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service