Hi All,

Could an Arducopter Ninja please help me out?  I have a Steadidrone Quad which I have just upgraded the firmware up to v3.0.1 Quad.  I have done all of the calibration to get it set up again, including the ESC automatic calibration. It seems fine now and I have no problem getting it to Arm/Dis-Arm and all of the motors seem to spin together.  I know the Arm/Disarm process is working as the LED goes to solid 'on' once armed, the throttle becomes active and the Mission Planner shows 'Armed/Disarmed' as appropriate.  Before I connected my APM to my computer I also had a 'double beep' which told me that the Quad was armed and a 'single beep' upon disarming.  My Quad still makes all of the appropriate start-up beeps.  

Can anyone please help me to bring the Arm/Disarm beeps back?  I have looked on the Wiki and here on the forum, but can't find anyone else with this problem.

My apologies if I am being a biff and this is a basic newbie oversight!

Cheers

Jimmy

Views: 433

Reply to This

Replies to This Discussion

Bumped to try to get a reply!  I have also noticed that I am not getting a GPS lock beep either.  Any thoughts?

Err, any thoughts at all?

Reply to Discussion

RSS

Groups

Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service