hi there, I just traying reset my apm board and I have CLI conecting bur in fly mode  is no conecting

I reload de firmware, reset de apm no results, any help?

Views: 173

Reply to This

Replies to This Discussion

Have you tried to reload the APM code? Reset button on oilpan/IMU may also help.

These suggestions are from the Arducopter troubleshooting guide in the manual.

regards, brett

Reply to Discussion

RSS

Groups

Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service