I've just released ArduPlane 2.62
The main reason for this release so soon after 2.61 is to fix elevon mixing. That was broken completely in 2.61. My apologies to everyone with an elevon plane!
Other changes in this release:
Arduplane 2.61 was found quite smooth going in AeroSIM-RC
I am having the same problem on an APM 1/2560. My system is not functioning as it did on 2.6 . I am going back to 2.6 for now
Did you erase the eeprom first? (CLI setup/erase)
Arduplane 2.61 Long flight tested on Flying Wing in AeroSIM-RC
Hi, can anyone explain the parameters ARSPD_OFFSET and ARSPD_RATIO? I'm having real trouble getting meaningful airspeed data. The parameter wiki says what the parameters are, but not what they do exactly, or how to calibrate the airspeed sensor.... thanks
Yes. As Asaak said everything seems to be moving in slow motion. I have another system with an AMP 2.0 running ArduPlane V 2.5 and will wait before upgradeing firmware to get the nav improvements.
A question about the software reboot: Code-wise it seems to be restricted to APM2. Is there any reason to believe the same method would not work for an APM1 1280 or is it just untested? Thanks!
Thanks, can anyone confirm that 2.62 is supposed to work with airspeed ?
I am unable to see AS in MissionPlanner, - but it works fine in test menu.
I´m having problems with esc initilization too. I use a turnigy plush 40A and it`s not starting.
I have another APM2 with the same esc and earlier version of ArduPlane and always worked.
Anyone have a solution? How can i install an earlier version of arduplane using the Mission Planner?
Asaak - Question Have you resolved your problem? If so, what resolved it?
I am still having major problems with AP 2.62.
Just to check my hardware I loaded Arducopter 2.73 without erasing or anything else. Arducopter loaded without problems. After loading I went to flight data and checked out the HUD action. The hud follows roll, pitch, and Yaw almost instantaniously. Also Transmitter calibration using tlementery was normal. OK the hardware is fine.
I did the exact same thing with ArduPlane 2.62 on the same hardware and guess what . Snails pace on Hud reaction to Roll, Pitch, and Yaw. There seems to be a major problem with the Mavlink system and 2.62 in general. Using the CLI calabration and testing of the hardware A to Z is normal. The numbers on all tests Roll, Pitch,Yaw,Compass, PWM, and Passthru follow inputs to the letter with no visable lag.
Help any one?
I'm having the same problem with Arduplane 2.62. I uploaded this morning and my HUD display does not react to movement around XYZ axises as I am moving it.