100KM

Ardurover on Turnigy trailblazer

I found the Turnigy trailblazer from hobbyking a fairly cheap, but still performant and fast base vehicle to start testing my APM1280 + imu and ardurover 2.20 firmware on it.

 

After some days of hairpulling, because a magnet from my camera lens was dangling too close to the magnetometer, I got it running pretty good.

With some finetuning and maybe some modifications I should be able to give the turnigy trailblazer some more speed.  And ofcourse record fpv video :-)

 

I hope we can pick up the development of ardurover, cause this is really a fun project !  

Ideas for improvements are welcome !

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –

Replies

  • 100KM

    My trailblazer is still running strong!  I did put a $5 cooler on the motor and some diff oil in the differentails.  Also reglued the tires with CA (just put some CA along the rim.

    It's a very fun car with awesome performance for fundriving.  I wouldn't recommend it for racing as it is not agile enough, but for a  apm rover you get a lot of bang for buck.  Spare parts are also very cheap at hobbyking, but are also available from redcat (it's the same car as the redcat earthquake 8E)

    Only 1 thing will make me advise against it : it seems it has dissapeared from the hobbyking international site and is only available in Germany, USA and AUS now.  So I'm a bit afraid that hobbyking may stop selling it, which could leave you searching for spare parts (not that you need any, so far I have only replaced 1 screw that fell out and got lost)

    Oh, and it's damn fun to give the $500 traxxas owners a run for their money.

  • Developer

    Hi u4eake,

    can you still recomment the trailblazer ?

    i need another vehicle soon and it seems that it could fit.

    Regards,

    Linus

This reply was deleted.

Activity

Liam left a comment on Agricultural UAVs
"Hi
I'm Liam from T-MOTOR. I would like to reach out to see if there is any possibility for us to work together.
We are a propulsion system manufacturer who offers motors, propellers and ESCs for all kinds of drone applications which vary from secur…"
Jun 30
Richard Cox left a comment on Australia
"Anyone in the DIYDRONES Australian subgroup based in Alice Springs, NT?
I am experimenting with Ardupilot (standard Arduplane), Pixhawk 4 FC in a 4-ch
RC "AXN Floater Jet" foamy plane..."
Jun 29
Omar Sykes left a comment on Australia
"Hi everyone, I am looking for someone who is good at drone building, repair and software in Adelaide. Please give me a call on 0477 319 219."
Jun 29
More…