I am looking for a guide to help with final assembly.

I have a Hexa 3DR with APM 1

How does the APM assembly mount to the plate?

Does the PDB just get sandwiched between plates?

How do I hook up the ESC's to the APM assembly?

Help???

Thanks in advance!

Randall

P.S. I found a lot of information on older models/versions but nothing for what I have.

Views: 205

Reply to This

Replies to This Discussion

Are you using the assembly instructions?

Found that BUT I have the HEXA 3DR everything is different (Frame, PDB etc...)

and that does not show connections between the boards also it looks like I do not have the correct connector cables for my TX/RX combo  (Spektrum DX7 with AR6200)

Here is the link for what I purchased

https://store.diydrones.com/ArduCopter_3DR_Frame_Motors_Kit_p/kt-ac...

Thanks in advance!

Randall

So use the Hexa instructions. They're right in the product listing

I asked Sales and in here before I ordered on what all I needed to build this, anything extra that was not in the kit etc..

Now it looks like I need:

https://store.diydrones.com/Jumper_cable_two_pin_female_15cm_p/ca-0...

More, There is nothing that I can remember that says I only need the signal from the PDB for the ESC's.....

and the ESC's have A,B,C and the motors have Red, Black Blue does the instruction show that?  I dont recall reading that either.

Thanks in advance!

Randall

Instructions on how to hook up the ESCs are in the manual. 

http://code.google.com/p/arducopter/wiki/AC2_Props_2

Reply to Discussion

RSS

Groups

Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service