Replies to This Discussion

Permalink Reply by Stephen R Mann on September 1, 2013 at 8:43am

Try switching motors.  If the motor still acts this way on the new location then it's a bad motor.

• ▶ Reply

Permalink Reply by Wessie on September 1, 2013 at 8:57am

Easy one.

try another esc on the motor, as Stephen suggested. If it IS the motor and not the esc, then...

1. Undo, and re-connect your bullet connectors

2. Re-solder the bullets onto the wires

3. resolder the wires at the Motor side.

4. If this sill does not work, then the motor is likely faulty.

In my experience a "chugging" motor is usually an indication of a bad connection somewhere.

• ▶ Reply

▶ Reply to Discussion