Quick question I am ready to cal my ESC’s again. But I do not want to blow it up again. I was thinking of unsoldering SJ1 and powering the board with usb Also I would be able to see the cal with the configurator. Then power the ESC’s and receiver with the battery. When all is done re solder SJ1. Does this sound ok?

Views: 518

Reply to This

Replies to This Discussion

Ok, I think I have it. it might not be the right way but it worked for me. I had to change the following:

#define MIN_THROTTLE 670


if (ch_yaw > 1800) {
motorArmed = 1;
minThrottle = 970;
Thanks, this fixed my problem too. Was frustrated for two weeks. I tried changing this before but not further than 900.
It's in the UserConfig.h header file.

line 68 or so.

Reply to Discussion



Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service