I re post my question here hoping someone will lend me a hand.

I am running APM 2.73 with RDF900 with default radio setting. I can not send any command from flight data tab, eg : change altitude, change mode ect... Each time I try a error massage come out ( error change altitude...)

The strange things is I have another plane with completely same equipment and firmware, run with the same notebook but it was fine. I can do everything via GCS.

Please let me know where should I check or any setting to adjust. Thanks

Views: 204

Reply to This

Replies to This Discussion

Are you using apm planner? Can you download the parameters?

Reply to Discussion

RSS

Groups

Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service