Hello everyone!

I've been having problems in loading firmware to pixhawk. I've used apm planner 2.0 as instructed. Pixhawk is connected to the computer via usb connector with peripherals connected to pixhawk which includes GPS with magnetometer, switch, buzzer and telemetry.Everytime I start loading firmware, it instructs me to unplug the pixhawk and plug it again afterwards. Status message will then be "downloading" then, "attempting to find com port" and stops. I checked again the pixhawk port in  the device manager and still it is present.

Can somebody tell me what to do please? or is the lacking of peripherals affect it as well? I hope somebody could help and could give a comment. Your comments will be very much appreciated and is a great help for me for sure. 

Thanks in advance,

Cherry

Views: 3695

Reply to This

Replies to This Discussion

I think you need to press the safety switch first before arming. have you do this procedure?

Cherry

You don't say what you did to get FW loaded. Please post what you did.

Hi Martin,

Actually, I've already posted how I get FW loaded. Please see the comment below(February 20, 2014 comment). 

Thanks,

Cherry

Reply to Discussion

RSS

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service