Hi there everyone, I'm currently working on a Pixhawk Flight Controller for my Master's Degree Thesis and i would like to know the steps that are necessary to read an analog sensor from ADC 3.3V port. I have been reading post's on DIY Drones community and i have already read the Dev. page on Ardupilot page several times.

My 1 million dollar question is:

1) Do i need to create new libraries and new parameters and add them to the main ArduPlane code in order to read the analog inputs?

Any help you could give me is helpfull.

Thanks so much in advance.

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –

Replies

This reply was deleted.

Activity