Configuration problem with RC Graupner MX-20
The RC is not recognized in the program, the movement of the stick is not displayed.
I did the manual calibration of the ESC and it is ok, so the receiver and transmitter are connected
The difference compared to the wiki is that I had to connect the ESC to channel 1 instead of 3
Any advice?
thanks

Views: 645

Reply to This

Replies to This Discussion

news
I managed to configure the RC in a CLI
tests are ok
in graphics mode, but the bars do not move
Is this normal?

Reply to Discussion

RSS

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service