Connecting a RS232 converter to an ATTOpilot?

Hi Guys,

I've just tried to connect one of these to my ATTOpilot V3.

I hooked it up like this......

ATTO                                               TTL to RS232

Telm IN -------------------------------------------TX-O

Telm Out------------------------------------------RX-I

GND------------------------------------------------GND

                                                       VCC (3.3V input)

The 3.3V is scaled down from 5V like this.

I can't seem to get it to work?

Am I missing something?

Should I connect is differently?

It works great with a FTDI (USB) but I need it to work from a DB9 RS232.

(I want to try it over IP as I have a great little IP to serial converter that I use allot at work)

Thanks in advance!

Scott

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –

Replies

  • Hi Scott!

    Do the Tx or Rx LEDs come on?

    Can you check that your 3.3V is in fact 3.3V when it is all powered up - I am worried that using a voltage divider to power a device will not give very good results.

    Cheers,
    Andrew.

This reply was deleted.

Activity

Liam left a comment on Agricultural UAVs
"Hi
I'm Liam from T-MOTOR. I would like to reach out to see if there is any possibility for us to work together.
We are a propulsion system manufacturer who offers motors, propellers and ESCs for all kinds of drone applications which vary from secur…"
Jun 30
Richard Cox left a comment on Australia
"Anyone in the DIYDRONES Australian subgroup based in Alice Springs, NT?
I am experimenting with Ardupilot (standard Arduplane), Pixhawk 4 FC in a 4-ch
RC "AXN Floater Jet" foamy plane..."
Jun 29
Omar Sykes left a comment on Australia
"Hi everyone, I am looking for someone who is good at drone building, repair and software in Adelaide. Please give me a call on 0477 319 219."
Jun 29
More…